Bnd-50 Se36 Instructions Guide

The RS-485 terminal has three screws: A (+), B (-), and GND.

⚠️ Do not use impact wrench for final torque — thread damage risk. bnd-50 se36 instructions

To ensure your BND-50 SE36 operates reliably for years: The RS-485 terminal has three screws: A (+), B (-), and GND

| Tool | Specification | |------|----------------| | Welder | MIG or TIG (steel, 0.030" wire) | | Angle grinder | With flap disc & cutoff wheel | | Drill | 12mm cobalt bit | | Punch set | Center punch | | Floor jack & jack stands | 3-ton min | | E36 rear subframe bushing tool | Or press | | Torque wrench | 20–150 Nm range | | Paint/primer | Rust-preventative (e.g., epoxy or zinc primer) | | Safety gear | Welding helmet, gloves, ear/eye protection | ⚠️ Do not use impact wrench for final

Let welds air cool. Grind any spatter. Apply weld-thru primer or 2 coats of epoxy rust paint. Do not paint internal bushing surface.