The Clarion PX-3994A-A manual diagrams a straightforward control layout. Here is the button guide:


If you cannot find the manual immediately, you do not need to wait. Based on reverse-engineered schematics of the Clarion PX series, here is the standard pinout for the 16-pin main power/speaker connector.

Note: Verify physically before connecting. If your unit has a 14-pin connector, stop and search for the specific variant.

| Pin # | Wire Color | Function | Voltage/Impedance | | :--- | :--- | :--- | :--- | | 1 | Orange / White | Illumination (Dimmer) | 12V (when lights on) | | 2 | Gray / Black | Front Right Speaker (-) | N/A | | 3 | White / Black | Front Left Speaker (-) | N/A | | 4 | Violet | Rear Right Speaker (+) | N/A | | 5 | Yellow | Memory (Constant 12V) | +12V (Battery Direct) | | 6 | Black | Ground (Chassis) | Negative | | 7 | Red | Accessory (Switched 12V) | +12V (Ignition) | | 8 | Blue / White | Amplifier Remote Turn-On | +12V (300mA max) | | 9 | N/A | N/A (Not used) | N/A | | 10 | Gray | Front Right Speaker (+) | 4-8 Ohms | | 11 | White | Front Left Speaker (+) | 4-8 Ohms | | 12 | Violet / Black | Rear Right Speaker (-) | N/A | | 13 | Green | Rear Left Speaker (+) | 4-8 Ohms | | 14 | Green / Black | Rear Left Speaker (-) | N/A | | 15 | N/A | N/A (Not used) | N/A | | 16 | Blue | Power Antenna | +12V (when tuner active) |

Critical Warning: Do not connect the Orange/White dimmer wire to ground. If your vehicle lacks a dimmer circuit, cap this wire with electrical tape. Connecting it to ground will blow the internal illumination fuse (which is soldered onto the board—a nightmare to replace).


Because Clarion was acquired by Faurecia and subsequently merged into Forvia, legacy support for early 2000s models is thin. Here is the prioritized strategy to locate the authentic PDF.