Fanuc 10m Parameter Manual -

This is where the manual pays for itself. You must type 20-30 parameters from the 9100 block exactly as listed in the original machine builder’s supplement (or the default Fanuc list). One wrong bit and the machine will power up with "PC NOT READY."

| Param | Use | |-------|---------------------------------------------| | 400 | Max spindle speed (rpm) | | 401 | Gear selection: ratio code or direct drive | | 405 | Spindle orientation position (for tool change) |

Warning: Do not download "Fanuc 10M Parameter Manual.exe" files. These are infostealers. Real PDFs are 20-50 MB, not 500 KB. Fanuc 10m Parameter Manual

The manual groups them closely. Parameter 401 is Spindle gain. Parameter 402 is Axis gain. Swapping them will cause a "SV006" alarm.

Before modifying parameters, the operator must enable the write function. This is where the manual pays for itself

Standard Procedure:

The Fanuc 10M uses 8-bit parameters. The manual expresses values like: 0320 (Bit: 7 6 5 4 3 2 1 0) If the manual says "Set Bit 3 and Bit 7 to 1," that equals binary 10001000 which is decimal 136. You must convert it. Keep a binary table taped to the manual. The manual groups them closely

The Parameter Manual is not a standard instruction book; it is a dictionary of binary codes and hexadecimal values that define the "personality" of the machine. While the Fanuc Operator's Manual tells you how to run the machine, the Parameter Manual tells the CNC what kind of machine it is.

It controls everything from: