Bunlara da Bakın
These parameters control how the system reads tape/DNC and metric/inch modes.
| Parameter # | Description |
| :--- | :--- |
| 0000 | Input/Output Units (Bit type).
Bit 2 (IO): 0 = Metric, 1 = Inch.
Bit 4 (ISO): 0 = EIA code, 1 = ISO code (ASCII). |
| 0001 | Tape Format.
Bit 5: Tape format selection (usually specific to the machine builder). |
| 0002 | Stop Mode.
Defines how the machine stops during reset or emergency stop. | fanuc 11m parameter list
The 11M uses a 4-digit or 5-digit parameter numbering system (typically 0000 to 9199, depending on options). Servo parameters (0430+):
| Parameter Range | Category | Description | | :--- | :--- | :--- | | 0000 – 0059 | Option Parameters (NC) | Enables live tooling, rigid tapping, custom macros, DNC, etc. | | 0060 – 0089 | Axis Configuration | Stroke limits, axis direction, mirror image. | | 0090 – 0109 | Feedrate & Acceleration | Rapid traverse (G00), cutting feedrate limits (G01). | | 0110 – 0139 | Servo & Motor Parameters | Position loop gain, feedforward coefficient, backlash compensation. | | 0140 – 0159 | Reference Point | Grid shift, reference return direction, deceleration points. | | 0160 – 0199 | Spindle Parameters | Gear ratios, C-axis control, orientation stop position. | | 0200 – 0239 | Coordinate System | Absolute/incremental, diameter programming, I/J/K specifications. | | 0240 – 0259 | Tool Offset | Number of tool offsets, length/radius type, wear compensation. | | 0260 – 0299 | Automatic Operation | Single block, dry run, feed hold behavior. | | 0300 – 0319 | Editor & Program | Tape coding (ISO/EIA), punch code, program number lock. | | 0320 – 0359 | Communication (RS-232) | Baud rate, stop bits, parity, DC code control (Xon/Xoff). | | 0360 – 0399 | Diagnostic Parameters | Self-diagnostic thresholds, watchdog timers. | | 0400 – 0429 | Pitch Error Compensation | Compensation points per axis, interval, direction. | | 0430 – 0549 | SERVO PARAMETERS (Critical) | Requires IPL mode to change. (Motor model, current limit, velocity gain, PWM frequency). | | 0900 – 0939 | Option Parameters (High Security) | Hideable via parameter 10.4. Control software options. | | 5000 – 9199 | Macro & Customization | User macro variables, arguments, and local variables. | These parameters control how the system reads tape/DNC
700) and press INPUT or SEARCH.INPUT.Note: this is a generic mapping—actual numeric P-numbers differ by firmware revision and OEM. Use as conceptual reference.
Practical note: Fanuc often stores multiple tuning sets per axis (slot 1, slot 2 …). Changing these affects dynamic response; tune methodically with appropriate tools (oscilloscope, response monitor).
| Builder | Machine Model | Parameter Notes | |---------|--------------|------------------| | Mori Seiki | MV, MV-JR | 0100–0199 servo, 600–699 offsets | | Mazak | VQC, HQC | 0300–0399 pitch error | | Kitamura | Mycenter | 8000.0 enable, 0512 tool changer | | Haas (early) | VF series | Not FANUC – different control |
