Fanuc Series Oitf Plus Programming Manual -

The 0i-TF Plus controls a 2-axis Lathe (typically).

The manual dedicates a full section to this graphical interface. It allows: fanuc series oitf plus programming manual

Reading the manual passively is not enough. Here are three warnings highlighted in the "Note" sections of the Fanuc Series Oi-TF Plus documentation that programmers often ignore: The 0i-TF Plus controls a 2-axis Lathe (typically)

The manual emphasizes turning-specific codes: The manual dedicates a full section to this

| G-code | Function | Notes for Oi-TF Plus | |--------|----------|----------------------| | G71 | Stock removal in turning (Type I & II) | Supports pattern repetition with constant depth or cutting amount. | | G72 | Facing cycle | For radial roughing. | | G73 | Pattern repeating cycle | For roughing castings/forgings. | | G76 | Threading cycle | Multi-repetitive cycle with infeed angle control (parameter 5130). | | G83 | Peck drilling cycle | For deep hole drilling on lathe with live tools. | | G96/G97 | CSS / RPM mode | CSS with G50 max speed clamp. |

WARNING

The manual explains the critical logic behind Tool Offset Memory (Memory A, B, or C). It details how to program:

O2000;
#1 = 50.0;    (Start X diameter)
#2 = 10.0;    (Groove width Z)
#3 = 0.2;     (Incremental step)
WHILE [#1 GT 30.0] DO1;
G00 X#1 Z5.0;
G01 Z-#2 F0.05;
G00 Z5.0;
#1 = #1 - #3;
END1;
M99;