Foxconn N15235 Front Panel Connectors - Google -

If you want, I can:

(Invoking related search suggestions.)

The Foxconn N15235 marking is often found on motherboards like the Foxconn G31MXP or 6100M2MA-RS2H. While "N15235" is a regulatory code rather than a specific model number, these boards typically share a standard 10-pin front panel header (FP1) for connecting case buttons and LEDs. Foxconn N15235 Front Panel Header (FP1) Pinout

The front panel header is usually located on the bottom right edge of the motherboard. It typically follows a standard layout where the top row has 5 pins and the bottom row has 4 pins (with one pin missing for orientation). Description HD-LED+ Hard Drive Activity LED Positive (+) HD-LED- Hard Drive Activity LED Negative (-) PWR-LED+ Power Status LED Positive (+) PWR-LED- Power Status LED Negative (-) RESET-SW Reset Switch No Polarity RESET-SW Reset Switch No Polarity PWR-SW Power Switch No Polarity PWR-SW Power Switch No Polarity NC Not Connected / Reserved Empty Missing pin for orientation Foxconn N15235 Front Panel Connectors - Google

(Sources: ManualsLib Foxconn G31Mv-K , Scribd Foxconn Manual ) Connecting Your Front Panel Components

The reset switch connector is a 2-pin connector that connects to the system's reset button. When the reset button is pressed, the RESET leg is connected to the GND leg, signaling the motherboard to reset the system.

In a perfect world, every motherboard uses the Intel standard pinout (two rows of 5 pins with one missing key pin). The Foxconn N15235 mostly follows this, but because this board was used across multiple chassis (HP, eMachines, Gateway), the color-coding of the wires may vary wildly. If you want, I can:

Warning: Do not trust the wire color alone! Always assume red is positive (+), but sometimes manufacturers swap them. Use the pinout diagram below as your source of truth.

Dell uses a completely different pinout (often with a missing pin in position 3). An Intel standard diagram (from a DH67BL board) will not work on a Foxconn N15235. Ignore any guide that shows a 2x5 grid with a missing pin in the middle.

The Foxconn N15235 is a resilient motherboard that powers many legacy systems. The front panel connectors are its only confusing feature. By using the pinout diagram in Part 2 (9-pin: PWR on 2/4, HDD on 5/7, PWR_LED on 1/3) and troubleshooting with Part 4, you can revive an old HP tower or repurpose this board for a retro gaming build. (Invoking related search suggestions

Final Checklist for your Google search mission:

If you are still stuck, search for "HP Compaq SG3-350UK Service Manual" – that document contains the official OEM schematic for the Foxconn N15235.

Now go plug in those cables. Your PC is waiting to boot.

The Foxconn N15235 motherboard features a standard front panel header (FP1) in the bottom right corner for connecting case switches and LEDs, typically labeled for power/reset switches and HDD/power LEDs. The layout usually consists of two rows, with keying provided by a missing pin, requiring careful attention to LED polarity, which can be reversed if the LED fails to light. For diagrams and installation instructions, visit Yumpu. Front Panel Cables Made Simple – Most Common Mistakes