Gps Tracker Parameter Editor May 2026
Beyond basic APN and server settings, expert users manipulate these parameters to achieve specific behaviors:
Use these defaults as starting points; adjust for battery, coverage, and use case. gps tracker parameter editor
Most modern trackers (TK-Star, Queclink, Jimi, Concox, Teltonika, SinoTrack) use a parameter table structure. Understanding this table is key. Beyond basic APN and server settings, expert users
| Parameter ID | Name | Typical Values | Description | | :--- | :--- | :--- | :--- | | 1 | APN | internet, telstra.datapack | Access Point Name of local carrier | | 2 | Server IP | 52.14.120.89 | Destination for GPRS data stream | | 3 | Server Port | 7008, 8010 | TCP/UDP listening port | | 4 | Heartbeat Interval | 60, 300, 600 (seconds) | How often to send "still alive" signal | | 5 | Movement Start Upload | 10 (meters), 0.1 (minutes) | Distance or time before waking | | 6 | Sleep Mode | 0=Off, 1=Light, 2=Deep | Power saving strategy | | 7 | Geofence 1 | Lat/Lng + Radius | Fence center and radius in meters | | 8 | Time Zone | -5, 0, +8 | Offset from UTC | | 9 | Ignition Detection | 0=Disable, 1=Digital, 2=ACC | How to detect engine ON/OFF | Location reporting
A parameter editor gives you a GUI to change these IDs without memorizing arcane SMS commands like PARAM 1,1,internet,0,0#.
Parameters are stored in a JSON schema:
"param_id": "report_interval",
"type": "integer",
"unit": "seconds",
"range": [5, 3600],
"protocol_field": "interval_sec"
