This is the most reliable method for changing network settings.
Open Your Web Browser. Use Internet Explorer Mode in Edge (most reliable for older IP cameras), Chrome with the IE Tab extension, or Firefox. Note: Modern Chrome often blocks the plugins required for video streaming.
Enter the IP Address. Type http://[IP_ADDRESS_OF_CAMERA]:80 into the address bar. For example: http://192.168.1.105:80.
Login. A pop-up or embedded login form will appear. Enter the Hipcam default login: admin / 123456. hipcam default login
The previous owner or a family member may have changed the password and forgotten. The only solution is a hard factory reset.
How to reset a Hipcam camera:
Securing your device takes less than two minutes. Follow these steps: This is the most reliable method for changing
A: Hipcam focuses on low-cost hardware and uses a lightweight, embedded web server. The interface is functional but dated. For a better experience, use third-party software like VLC, OBS Studio, or SmartPSS.
A: This is likely a codec issue. Hipcam cameras often use MJPEG or H.264. Ensure you have installed the correct ActiveX plugin (for IE mode) or use a browser like Pale Moon. Also, check the “Video Format” settings inside the camera config—set it to “H.264” for broader compatibility.
If you only need to view the camera at home, block the camera from accessing the internet entirely. Open Your Web Browser
You might think, “My camera is inside my house, behind my WiFi. No one can reach it.”
Wrong.
Most Hipcam devices use P2P (Peer-to-Peer) technology or UPnP. This means the camera actively opens a tunnel to the internet so you can watch it from your phone. Unfortunately, botnets (like Mirai) constantly scan the internet for exactly these default logins.
If you leave admin / 123456 active: