Nalco 73385 Msds -

Do not land-apply, incinerate without scrubbers, or pour down the drain.

Recommended disposal: Contact a licensed hazardous waste transporter. Nalco 73385 may qualify as RCRA hazardous waste code D002 (Corrosive - pH <2 or >12.5) . Some states also list molybdenum as a toxic metal.

Dilution is not disposal – diluting to lower pH does not remove molybdenum from the waste stream.

Empty containers: Triple rinse with water, and treat the rinse water as hazardous waste. Crush or recycle steel drums only after removing all labels and verifying no residue remains.

Nalco 73385 is hazardous to the aquatic environment if released in large quantities:

Persistence: Molybdate is not biodegradable (it is an inorganic ion); it will accumulate in sediments and aquatic plants. Do not discharge into lakes, rivers, or municipal sewers without an approved pretreatment permit. nalco 73385 msds

Typical components (proprietary, but common in Nalco 73385):

Reviewer’s note: The SDS will list exact percentages as trade secret ranges. The presence of azoles means the product is not compatible with yellow metals at high concentrations but protects them at low treatment levels.

Reviewer’s note: This is the weakest point in the SDS – product persists in the environment. Use in closed-loop systems or with proper blowdown treatment is strongly recommended.

An SDS is required by law (OSHA, GHS, REACH) to communicate hazards, handling, and emergency measures. Below is a critical review of the typical sections of the Nalco 73385 SDS.

The Nalco 73385 MSDS is not a document to file and forget. It is a living guide that, when integrated with proper training and engineering controls, allows your facility to benefit from superior corrosion protection without endangering your workforce or the environment. Always verify that you have the latest version directly from Ecolab’s website or your authorized distributor, and never hesitate to contact Nalco Water’s technical service department for application-specific questions. Do not land-apply, incinerate without scrubbers, or pour

Staying safe means staying informed. Keep the MSDS accessible, understood, and respected.

Disclaimer: This article is provided for informational purposes only and does not substitute for the official SDS issued by the manufacturer. Always follow the specific instructions on the SDS for the exact product lot and date of manufacture.

NALCO 73385 is a broad-spectrum, non-oxidizing biocide primarily used to control slime-forming and sulfate-reducing bacteria in recirculating cooling towers and closed-loop systems. HKCT Malaysia Key Product Information Application:

Specifically designed for closed water loops due to its efficacy at elevated pH and its chemical persistency. Hazard Profile:

While full MSDS/SDS details for this specific product are often restricted, related Nalco biocide formulations (like 7338) are classified as and can cause irreversible eye damage and skin burns. Environmental Impact: Nalco 73385 is hazardous to the aquatic environment

It may meet criteria for hazardous waste (RCRA) and is considered acutely hazardous to the environment if disposed of improperly. HKCT Malaysia Safety and Handling (General Guidelines)

Based on typical safety requirements for Nalco water treatment biocides: Personal Protective Equipment (PPE): Wear a face shield and chemical splash goggles.

Use impervious gloves (nitrile or butyl), rubber boots, and a chemical-resistant apron. Respiratory: Use in well-ventilated areas to avoid breathing vapors. Emergency Measures: Eye Contact:

Immediately flush with water for at least 15 minutes and seek medical advice.

Avoid contact; use liquid-binding materials like sand for cleanup and prevent the product from entering drainage systems. files.dep.state.pa.us How to Obtain the Official MSDS

Nalco Water (an Ecolab company) does not typically provide these safety data sheets for open download online. To get the most accurate and current version for your specific region, you should: Use the Official Request Form: Nalco Water SDS Request Page to submit a formal inquiry. Contact Customer Service: You can contact your local sales representative or use the WhatsApp chat feature if available via regional distributors like HKCT Malaysia for the manufacturer? Others: NALCO 73385 - HKCT Malaysia