Rail Timer Instructions — Skope Heated Towel

This timer runs continuously. You set when the rail turns on and off each day.

Set your Skope timer to run only 2–4 hours before you shower/bathe and 1–2 hours after. Running all day costs roughly 10× more energy.

Need a specific manual?
Skope includes a quick-start guide with each towel rail. You can also download the full manual from skope.com under “Support” → “Heated Towel Rails.”

Skope heated towel rails are often paired with external timers like the Heirloom Timekeeper Plus

or similar digital controllers to maximize energy efficiency. These timers allow you to automate heating cycles so your towels are warm exactly when you need them. Setting the Current Time

To ensure your programmed schedules run correctly, you must first set the internal clock: skope heated towel rail timer instructions

Access Setup: If your timer has a front latch, pull it from the bottom to reveal the buttons.

Set Day/Time: Press and hold the CLOCK button. While holding it, use the HOUR, MIN (minutes), and DAY keys to adjust to the current settings. Save: Release the CLOCK button to store the data. Programming a Heating Schedule

Most digital controllers allow you to set specific "On" and "Off" windows for different days of the week:

Enter Program Mode: Press the PROG (or PG) key once. The screen should display "Timer 1 On".

Set "On" Time: Use the HOUR and MIN keys to select when you want the rail to start heating. This timer runs continuously

Set "Off" Time: Press PROG again until "Timer 1 Off" appears. Use the same keys to set the finish time.

Confirm: Press the CLOCK button to exit and save your schedule. Using Pre-Set "Eco" Modes If you are using a simplified controller like the Heirloom Timekeeper Plus

, you can cycle through automatic cycles by pressing the main button:

3-Hour Boost: Press once; the rail runs for 3 hours and stays off.

Morning Cycle: Press twice for 5 hours on / 19 hours off daily. Need a specific manual

Dual Cycle: Press three times for 4 hours on / 8 hours off twice daily.

Even Split: Press four times for 6 hours on / 6 hours off daily. Quick Tips for Best Use Setting a Digital Timer(Step by Step Instructions)

If your Skope rail has a simple rotary dial (no LCD screen), the instructions are different. This is a 24-hour mechanical or electro-mechanical timer.

Typical setting: For the rail to run from 6 AM – 9 AM and 5 PM – 11 PM, ensure the segments are pushed IN for those 9 hours total.

Override: Turn the dial slightly or use the dedicated I/O switch.

Common button symbols:
SET / P = Program
▲ / ▼ = Adjust
MODE = Auto / On / Off
OK / ENTER = Confirm