/ ts1162 installation manual / ts1162 installation manual

Ts1162 Installation Manual [LATEST]

| Code | Meaning | Fix | |------|---------|-----| | E01 | Temp probe short | Replace probe | | E02 | RH sensor stuck | Desiccate for 24 hrs | | E07 | CO2 reading >3000 ppm | Vent room, re-zero | | E14 | Relay 1 welded | Replace relay board | | E99 | Firmware corruption | USB reflash (see Appendix C) |

The TS1162 typically requires:

From the manual's terminal diagram (example): | Terminal | Signal | |----------|--------------| | L / + | Line (AC) / V+ (DC) | | N / - | Neutral / V- (DC) | | ⏚ (PE) | Protective Earth | ts1162 installation manual

Installation sequence:

  • Example CLI commands (adapt to device syntax):
  • Set hostname and timezone.
  • Enable SSH and disable insecure services (Telnet/unused protocols).
  • Save configuration to persistent storage (e.g., write memory / save).

    • A professional installation is not complete without calibration. The TS1162 installation manual provides two methods: | Code | Meaning | Fix | |------|---------|-----|

    The screen will show “TS1162 – Initializing”. After 20 sec, a beep indicates ready.

    If screen shows “ERR: NO PROBE”: Check RJ45 connector on bottom. From the manual's terminal diagram (example): | Terminal

    The TS1162 often includes:

    Critical note from the TS1162 installation manual:
    Separate low-voltage signal wires from high-power AC wires by at least 10 cm (4 inches). Use shielded twisted pair for analog inputs and ground the shield only at one end (controller side).

    To top

    On this Page

    ← On this Page