Ttl Models Carina Zapata 002 Install -

Do not begin this installation without the following gear. Improper tools will ruin the resin.

Safety Gear:

Cutting & Shaping:

Adhesives & Fillers:

Pinning Hardware:

Alignment Aids:

Inspect the Carina Zapata 002 under a bright lamp. You will find: ttl models carina zapata 002 install

Use flush cutters to remove large pour stubs, staying 2-3mm away from the part surface. Then switch to sanding sponges:

For seam lines on delicate areas like the nose or lips (if the head is separate), use the back of a hobby knife blade to scrape perpendicularly. Never slice toward your hand.

Place all resin parts in a bowl of warm water with heavy-duty dish detergent. Scrub with a soft toothbrush. Rinse thoroughly. Allow to air dry for 24 hours. If you see water beading on the surface, wash again. Do not begin this installation without the following gear

Before you start the install, familiarize yourself with the contents. TTL Models is known for crisp casting, but every resin kit has quirks.

Included in the TTL Models Carina Zapata 002 kit:

Critical note: TTL Models does not include tires, wheels, or axles. You must source these from a donor kit (Aoshima or Fujimi VIP car kits work best) or aftermarket 3D printed sets. Cutting & Shaping: